@fm
Thank you again for your answer. I am still stuck with this issue.

As far as I did have any answer from waveshare or simcom yet I did again full Check of the programm.

The following things are working:

• Network connection
• MQTT Connection to test.mosquitto.org
• PUBLISH via MQTT works too

I meant AT+CSETCA? returns error. But also AT+CSETCA=? return ERROR which should not happen i guess.

The following commands i tried are also working:
AT+CHTTPCREATE?
AT+CHTTPCREATEEXT?

Source of the Commands is: SIM7020 Series_AT Command Manual_V1.03.pdf

Two aspects I am thinking about:

• Is there any Pre-Condition to “activate” the AT+CSETCA? and a I still overead this in the doc files?
• If the Command AT+SCETCA is not kown be my devices, are they the wrong devices? But I didn’t find any Note that SIM7020E is not working with MQTTs

@fm Hello agewin and thanks a lot.

I don’t think that the G or E Version is different in this aspect. Because there is no difference mention in the manual. What Firmware are you using? Mine is: 1752B07SIM7020E on both devices.

I now tried everything as above mentioned with my second raspberry pi. Same result.

I read the “SIM7020 Series_AT Command Manual_V1.05” again and found there the example:
AT+CSETCA?
which should result in OK

But this also ends in an Error in my case. Therefore it looks like the command ist unkown for both of my devices.

I now tried to contect the manucfacturer to get any progress. I’ll let you know what the error was if i find a solution.

@fm Thank you for your answer

Unfortunatly i’ve already read this post and tried it too.

I only return “ERROR” as a result. Even with the first string:

From the console log:
AT+CSETCA=0,1492,1,0,“-----BEGIN CERTIFICATE-----\n”

ERROR

What do you mention with:
@fm said in SIM7020e MQTT/S TLS:

Note: If I try to download the certificate a second time w/o power-cycling the modem, I’ll get an error.

What is w/o power-cycleing? Perhaps I overlook there something…

Hi everybody,

i am trying to connect a SIM7020E via MQTTs now for days. But i can’t find a way to make in work.
Connection via MQTT with test.mosquitto.org was successful. Therefore i would estimate, that the Simhat is working properly.

To connect the MQTTs I first try to insert the Certifcate’s Data.

But even with the first command it fails. I tried different ways of \r, \n for the line break:

AT+CSETCA=0,1492,1,0,“-----BEGIN CERTIFICATE-----\rMIIEDzCCAvegAwIBAgIUJQumG+G91plGk7”

AT+CSETCA=0,1492,1,0,“-----BEGIN CERTIFICATE-----\r\nMIIEDzCCAvegAwIBAgIUJQumG+G91plGk7”

AT+CSETCA=0,1492,1,0,“-----BEGIN CERTIFICATE-----\nMIIEDzCCAvegAwIBAgIUJQumG+G91plGk7”

AT+CSETCA=0,1492,1,0,“-----BEGIN CERTIFICATE-----MIIEDzCCAvegAwIBAgIUJQumG+G91plGk7”

Every of the above mentioned ended up in the Result Message “ERROR”

Also “AT+CSETCA?” results in an Error.

How can I debug this stuff?

I am grateful for any hint or help!